Cisco PWR-8200-AC Full English Description

Product Overview

Important Note: Catalyst 8200 chassis supports single or dual 1+1 redundant PSU configuration. This unit does not supply PoE power. For deployments requiring PoE on NIM switch modules, separate external PoE power accessories are required.

Key Features

1. 250 Watt Continuous Rated Output

   Provides sufficient power for standard C8200 router configurations with single NIM module installation. Supports dynamic load sharing when two identical PSUs are deployed redundantly.
2. Universal Wide-Range Global AC Input

   Worldwide auto-ranging mains specification:

• Input Voltage: 100 VAC ~ 240 VAC
• Operating Frequency: 47 Hz – 63 Hz
• Integrated IEC C14 power inlet for standard AC power cords

1. Front-to-Rear Native Chassis Airflow

   Airflow aligns with the thermal design of Catalyst 8200 1RU edge router chassis.

   Important Note: Always install identical PSU models within one chassis. Do not mix AC and DC power supplies. This PSU cannot be used on Catalyst 8300, ISR 4000 or Cisco 8000 Series IOS-XR routers.
2. Hot-Swap Support

   Supports Online Insertion and Removal. Technicians can replace faulty power modules without shutting down the router, delivering non-disruptive hardware maintenance and minimizing service interruptions.
3. LED Status Indicators & IOS-XE Telemetry

   Front panel bi-color status LEDs display AC input presence and operational health. The PSU continuously reports voltage levels, internal temperature and fault events to IOS-XE for remote monitoring, telemetry and alarm notifications.
4. Multi-Layer Hardware Protection

   Integrated overvoltage protection (OVP), overcurrent protection (OCP), overtemperature protection (OTP), surge protection and short-circuit protection to protect both the power supply and Catalyst 8200 router hardware.
5. High-Efficiency Power Conversion

   Optimized power conversion design reduces idle power consumption and thermal load, supporting stable 24/7 continuous rack operation for branch and cloud edge networking environments.

Supported Hardware Platforms

• Cisco C8200-1N-4T Catalyst 8200 Edge uCPE
• Cisco C8200L-1N-4T Catalyst 8200 Edge uCPE

Not compatible: C8300 series, ISR4000 series, Cisco 8201/8202 IOS-XR routers.

Typical Application Scenarios

• Enterprise SD-WAN edge gateway deployments
• Cloud uCPE and multi-service branch routing (IPsec VPN, firewall, NAT)
• Remote office and retail site network aggregation
• Spare replacement power supply for existing Catalyst 8200 installations
• Data center access edge and carrier lightweight customer premise equipment

Technical Specifications

• Form Factor: Internal pluggable FRU module for Catalyst 8200 1RU chassis
• Input Type: Universal 100–240 VAC wide-range AC
• Rated Continuous Output: 250W
• Hot Swappable: Yes
• Redundancy Mode: 1+1 redundant with automatic load sharing
• Airflow Direction: Front-to-Rear
• PoE Support: No
• Compliance: UL60950-1, EN60950-1, FCC Class A, CE certified, RoHS compliant

Short Version for E-commerce Listing